Design of the gearbox used in the rubber extrusion machinery

• They are cast with the high grade iron material
• They are coated with heat resistance material.
• They are coated with high performance oil that eliminates the need for constant oiling during its runtime
• They have gear bearing made up of steel alloys.
• They have an auxiliary system of heat transfer mechanism that compensates for high heat production due to friction forces generated due to constant movements of gears and pinions used in the gearboxes.
• They are highly powered efficient.
• They have a simple design as a result it can be easily and neatly installed.
• Require less maintenance.
• Don’t have consistent need for lubrication.
• It has a high transmission capacity.
• They have a longer shelf life.
• High output torque.
• Low noise and vibrations observed.
• Are equipped with torque multiplier.
• Heat transfer capacity.
• Made with heat resistant steel alloys which are used in the casting of gearbox bearings
• High output efficiency
• It could work in a range of energy.
• It is equipped with multi-gear to reduce the output speed.

So, while designing the gearboxes for the rubber extrusion companies, we keep certain aspects in our mind which are as follows:

• Control system of the gearboxes
• Body construction
• The raw material used in the machinery
• Optimized gear reduction ratio
• Installation of the machinery
• Output and input shaft ratios
• Gear reduction ratio
• Angry required by the helical gearboxes to work
• The load that can be carried by the gearboxes
• Maximum performance efficiency if the helical gearboxes.
• Maintenance issues
• Any erroneous performance issues faced by the machinery.