Your extruder line is running — then the temperature alarm trips. Within minutes, production stops, technicians scramble, and every idle minute costs money. Extruder gearbox overheating is one of the most common and costly failures in plastic processing facilities worldwide, yet it is almost entirely preventable with the right knowledge and maintenance practices. When a […]
A well-maintained extruder gearbox in a plastic processing plant should last 15 to 25 years. Most do not — and the gap between expected and actual service life almost always comes down to maintenance practices, operating habits, and gearbox selection rather than any inherent limitation of the equipment itself. In the competitive world of plastic […]
Did you know that over 70% of helical gearbox failures in plastic and rubber extrusion plants are directly linked to poor lubrication practices? Incorrect oil selection, missed change intervals, and contaminated lubricants silently destroy gearbox internals — leading to unexpected downtime, costly repairs, and lost production hours. Helical gearbox lubrication is not just about pouring […]
An unexpected gearbox failure on a plastic extrusion line does not just stop one machine. In a tightly scheduled production environment, it stops all the downstream processes that depend on that line — cooling tanks drain, haul-off equipment sits idle, pelletisers spin on nothing. For high-volume continuous production operations, every hour of unplanned downtime can […]
Every extruder gearbox sends warning signals before it fails — signals that, if recognised and acted upon promptly, allow maintenance to be planned and executed at a time and cost of your choosing rather than at the worst possible moment during a production run. The problem is that these signals are easy to miss when […]
